Contour Lines in Dallas County, Texas
Dallas County, Texas rises to 872 ft, 532 ft above its lowest ground. The map below draws contour lines across the county at the same intervals the Land Owl app uses.
Dallas County, Texas at a glance
| Highest elevation | 872 ft |
|---|---|
| Lowest land elevation | 340 ft |
| Total relief | 532 ft |
| Average elevation | 512 ft |
| Average slope | 2.3% |
| Land under a 5% grade | 87.3% |
| Land steeper than 15% | 0.5% |
Dallas County, Texas is home to 2,661,397 residents. Land Owl's contour line layer records the following within the county boundary — Highest elevation: 872 ft. Lowest land elevation: 340 ft. Total relief: 532 ft. Average elevation: 512 ft. Average slope: 2.3%. Land under a 5% grade: 87.3%. Land steeper than 15%: 0.5%. The figures on this page are derived from the same data the map renders, so they always agree. A free Land Owl account adds parcel boundaries, ownership records, flood zones, soils and wetlands over the same view.
Frequently asked questions
- How high is Dallas County, Texas, and how steep is it?
- The high point of Dallas County, Texas is 872 ft and its lowest land sits at 340 ft, with an average slope of 2.3% across the county. Elevations are measured from the USGS bare-earth elevation model inside the county boundary.
- Is this topographic map free to use?
- Yes. This map is free to view. A free Land Owl account unlocks the other data layers, parcel boundaries and ownership records.
- Where does this data come from?
- Land Owl draws contour lines from the USGS 3D Elevation Program (3DEP) bare-earth digital elevation model, served through AWS Terrain Tiles, and the elevation figures on this page are measured from that same model inside the county boundary. It is a screening surface at roughly 30-foot ground resolution, not a survey: it will not find a small berm, a ditch or a cut, and no lender, engineer or building department will accept it in place of a site survey.
- What contour interval does this map use?
- The interval changes with zoom, the way it does in the Land Owl app: 50-foot contours with a 200-foot index line when you are looking at the whole county, tightening to 10-foot and then 5-foot contours as you zoom into a parcel.
- Can I use these contours to plan a build or a drainage design?
- To shortlist land, yes — this is enough to tell a flat lot from a steep one and to see which way water leaves a property. To design on, no. These are bare-earth contours off a national elevation model at roughly 30-foot ground resolution; a driveway grade, a pad elevation or a drainage plan is drawn off a site survey.
See every layer over Dallas County
Parcel boundaries, ownership, flood zones, soils, wetlands and topography on one map.
Sign up free